Head Stock
8 different speeds possible. The headstock is of the all geard type, having splash lubrication. It houses the main spindle and the gears (for 8 different speed). The drive is taken from the motor, which is housed inside the left pedestal. And, the speed changeoverlevers are conveniently placed - to ensure quick setting of the required speed. The headstock is well seasoned and the gears aer hardened and ground. what's more the bed and other castings are all made ISI standards.

Apron with oil bath
The apron design is of the 'totally enclosed' type and comprises an oil bath, in which the gears of the apron run. The half nut lever is interlocked with the feed lever so that only can be operated when the others is not in use And, both the sliding and the surfacing feed can be engaged by the friction clutch lever.

Rigid tail stock
It is robust in construction and is fitted on a separate vee guide on the bed; this ensures highly accurate alignment along the entire length of the tailstock. Further, it can be set over on either side, for turning small tapers, And, it is possible to clamp the tailstock casting along the bed by using a single levered cam type clamp.

Standard Accessories
Hardened Bed, Chuck back plate, Centre Adopter, 2 Nos. MT-3 Dead Centres, Four position tool post, tool Post Spanner, Chip Tray, Thread dial indicator, Instruction manual & 2 HP Electric motor with electrical controls.

Optional Accessories
Taper Turning Attachment, Coolant pump (electrical) with Tank fittings and splash guard, 3 jaw chuck, 4 jaw chuck Rear Tool Post, machine Lamp, Revolving Centre, Face Plate, Carrier Plate, Steady Rest, Follow Rest.